NZXT Tempest EVO Manuel d'utilisateur télécharger pdf (Page 13)

NZXT. 11

External 3.5” Drive Bay Installation

The NZXT Tempest comes standard with one external 5.25” to 3.5”

bracket attached to the inside the 3

bay. Please follow the

directions below to install the external 3.5” devices:

1. Remove the 5.25” black mesh for the 5.25” to 3.5” bracket

bay.

2. Attach the floppy drive to the bracket.

3. Slide the bracket in from the front of the chassis.

4. Secure the bracket from inside the chassis using the screw

less locks or standard screws.

Internal 3.5” Drive Bay Installation

The NZXT Tempest comes standard with one external 5.25” to 3.5”

bracket attached to the inside the 3

bay. Please follow the

directions below to install the external 3.5” devices:

1. Open the side panel to gain access inside the chassis.

2. Take the screw less rails from the hard drive cage.

3. Attach the rails onto the hard drive.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Pas de commentaire

NZXT Tempest EVO Manuel d'utilisateur Page 13